Setting Up and Using Motion Detectors

This procedure initializes each Motion Detector so that the Console recognizes it.  You install a Motion Detector just like you install Door/Window Sensors.  Each Motion Detector will be assigned to one of the 16 zones.

1. Install a 9-volt alkaline battery in the battery compartment on the front of the Motion Detector.

2. Set the Console's slide switch to INSTALL.

3. Press [CODE] on the back of the Motion Detector with a pencil.

4. Press [TEST] on the back of the Motion Detector.  The Console's next unused zone indicator lights and the Console sounds a tone to indicate that the receiver accepted the Motion Detector.

5. Place one of the enclosed numbered stickers on the Motion Detector to show its zone number.

6. To set up additional Motion Detectors, (up to 16 zones) repeat steps 1-5.

7. Set Console to RUN (BUSY light stays on for 15 seconds)

Using the Motion Detector
Set switch on left (looking at back) to 
(1) to trip alarm if ANY movement is detected (most sensitive).
(2) to trip alarm if two movements detected or continuous movement detected in a short time (less sensitive to pets).

Using Motion Detector with Master Remote
Set switch on right to Home/Away.  Use the Master Remote Control to arm the system in the Away mode (which arms Door/Window Sensors AND Motion Detectors) or in the Home mode (which arms Door/Window Sensors only).

Testing the Motion Detector
Place Motion Detector within 100 feet of Console.  Walk past Motion Detector.  Console chimes.  Wait 20 seconds before repeating test (the Motion Detector has a 20 second lock-out to extend battery life).  Arm system, walk past Motion Detector: alarm trips.  Press [DISARM] on Remote.