Setting Up Door/Window Sensors

This procedure initializes each Door/Window Sensor so that the Console recognizes signals from the sensor.

1. Install a 9-volt alkaline battery in the battery compartment.

2. Set the Console's slide switch to INSTALL.

3. Press [CODE] on the sensor with a pencil.

4. Press [TEST].  The Console's next unused zone indicator lights and the Console sounds a tone to indicate that it accepted the sensor.

5. Set the MIN/MAX switch to MIN to protect a window.  Set to MAX to protect a door.

6. Place one of the enclosed numbered stickers on the sensor to show its zone number.

7. To set up additional sensors, (up to 16) repeat steps 1-6.

When you set the Console back to RUN it plays back the stored message and the BUSY light stays on for 15 seconds.

Setting Up Remote Control(s)

This procedure initializes each Remote Control so that the Console recognizes its commands.

KF574 Key Chain
1. Install two AAA batteries

2. Set the Console's slide switch to INSTALL.

3. Press [ARM] on the KF574

The Console emits a tone.  If you do not hear a tone, press the KF574's [CODE] button with a pencil.  Then repeat this step.

When you set the Console back to RUN it plays back the stored message and the BUSY light stays on for 15 seconds.

SH624 Security/Home Automation Remote Control
1. Install four AAA alkaline batteries in the battery compartment.

2. Set the Console's slide switch to INSTALL.

3. Press [ARM HOME] or [ARM AWAY]

The Console emits a tone.  If you do not hear a tone, press the [CODE] button with a pencil.  Then, repeat this step.

When you set the Console back to RUN it plays back the stored message and the BUSY light stays on for 15 seconds.

Installing Sensors

1. Set the switch on the front of the Door/Window Sensor to MIN if you are using it to protect a window or to MAX if you are using it to protect a door.

2. Set the switch inside the Door/Window Sensor's battery compartment to the right - N.C. (Normally Closed).  The magnetic switch supplied with the sensor is the N.C. type.

3. The sensor and magnetic switch supplied are already connected together.  If you need a longer wire, use any suitable wire to connect the magnetic switch to the Door/Window Sensor's two screw terminals.

4. Select a location for the Door/Window Sensor.  We recommend that you purchase enough sensors to protect the front and back door and any windows that are obscured from view or easily accessible (including basement windows).

5. Mount the Door/Window Sensor and the magnetic switch in the intended location using the supplied screws or double sided tape.

6. Install the magnet using the supplied screws or double sided tape.

Do not mount the magnet directly onto a metal surface, use a wood or plastic spacer.

7. Check for proper alignment by opening the door or window.  The light on the sensor turns on each time you open the door or window.

Typical Mounting Methods

First attach the sensor's back cover to the wall.

Then slide the sensor onto the cover.

Windows

Doors